Algorytmy konstrukcji obrazów  w systemach tomografii procesowej

Krzysztof Grudzień; Zbigniew Chaniecki; Dominik Sankowski

doi:10.56583/frp.1982

Data publikacji : 2015-12-30

Nr 3 (2015)

Algorytmy konstrukcji obrazów w systemach tomografii procesowej

Krzysztof Grudzień

Zbigniew Chaniecki

Dominik Sankowski

DOI: https://doi.org/10.56583/frp.1982

Abstrakt

Tomography is one of the methods used to obtain cross-sectional images of the analysed object. This imaging technique has been used for many years in medicine, providing significantly higher efficiency of patient’s diagnosis. In recent years, the imaging method has also found application for visualization of industrial processes. The article describes the tomographic image construction methods used in the modules of monitoring of dynamic industrial processes. Introduction to methods of the inverse problems solutions in tomography systems, from a practical point of view, was presented, with particular emphasis on the electrical capacitance tomography. It was shown how based on the mathematical theorems and knowledge about physics rules, concerning the behaviour of measurement signal in tomography sensor, is possible to construct cross-sectional image of industrial process. In article the image construction steps were explained and discussion on the impact of various factors on the quality and speed of imaging was conducted.

Słowa kluczowe:

problem odwrotny, przemysłowa tomografia procesowa, elektryczna tomografia pojemnościowa

Inne teksty tego samego autora

Zbigniew Chaniecki, Krzysztof Grudzień, Dominik Sankowski, Wizualizacja danych tomograficznych w diagnostyce procesów przemysłowych , Fides, Ratio et Patria. Studia Toruńskie: Nr 3 (2015): CZŁOWIEK I CYBERPRZESTRZEŃ

Szczegóły

Bibliografia

Statystyki

Autorzy

Pobierz pliki

pdf.

Zasady cytowania

Grudzień, K., Chaniecki, Z., & Sankowski, D. (2015). Algorytmy konstrukcji obrazów w systemach tomografii procesowej. Fides, Ratio Et Patria. Studia Toruńskie, (3), 99–127. https://doi.org/10.56583/frp.1982

Wskaźniki altmetryczne

Cited by / Share

Licencja

Utwór dostępny jest na licencji Creative Commons Uznanie autorstwa – Użycie niekomercyjne – Na tych samych warunkach 4.0 Międzynarodowe.

Bibliografia

Banasiak Robert i in., Study on two-phase flow regime visualization and identification using 3D electrical capacitance tomography and fuzzy-logic classification, “International Journal of Multiphase Flow” 2013, vol. 58. DOI: https://doi.org/10.1016/j.ijmultiphaseflow.2013.07.003

Beck Maurice S., Pląskowski Andrzej, Cross correlation flowmeters, their design and application, Bristol 1987.

Brandisky Kostadin i in., Electrostatic Field Simulations in the Analysis and Design of Electrical Capacitance Tomography Sensors, „Automatyka” 2010, t. 14, z. 3/2.

Brown Bryan H., Barber David C., Seagar Andrew D., ,,Applied potential tomography: possible clinical applications, „Clinical Physics and Physiological Measurement” 1985, vol. 6. DOI: https://doi.org/10.1088/0143-0815/6/2/002

Chaniecki Zbigniew, Algorytmy przetwarzania i analizy danych pomiarowych elektrycznej tomografii pojemnościowej w diagnostyce wybranych procesów przemysłowych, Rozprawa doktorska, Politechnika Łódzka 2006.

Cierniak Robert, Tomografia komputerowa. Budowa urządzeń CT. Algorytmy rekonstrukcyjne, Warszaw 2005.

Di Monaco Antonio, Sassi Giancarlo, Vanzan Roberto, Full Field Flow Measurements by Digital image processing, Imaging in Transport Processes, [Sideman and Hijikata eds.], Begell House 1993.

Garbaa Hela i in., Neural network approach to ECT inverse problem solving for estimtion of gravitational solids flow, Federated Conference on Computer Science and Information Systems 2014. DOI: https://doi.org/10.15439/2014F368

Grudzień Krzysztof i in., Description of the silo flow and bulk solid pulsation detection using ECT, „Flow Measurement and Instrumentation” 2010, vol. 21, Issue 3. DOI: https://doi.org/10.1016/j.flowmeasinst.2009.12.006

Grudzień Krzysztof i in., Multi-measurement system of gravitational flow process in slim large-scale silo, 7th World Congress on Industrial Process Tomography, Cracow 2013.

Grudzień Krzysztof i in., Tomography data processing for multiphase industrial process monitoring, Computer Vision in Robotics and Industrial Applications, Sankowski & Nowakowski (eds.), Singapore: World Scientific.

Grudzień Krzysztof, Algorytmy segmentacji dla potrzeb wizualizacji parametrów diagnostycznych przepływów wielofazowych w wybranych systemach przemysłowych, rozprawa doktorska, Łódź 2007.

Jaworski Artur J., Dyakowski Tomasz, Investigations of flow instabilities within the dense pneumatic conveying system, „Powder Technology” 2002, vol. 125. DOI: https://doi.org/10.1016/S0032-5910(01)00516-2

Johansen Geir A. i in., Non-Destructive Monitoring of Multiphase Hydrocarbon Flow by HighSpeed Gamma-Ray Tomography, 11th European Conference on Non-Destructive Testing (ECNDT 2014), Prague 2014.

Kaczmarz Stefan, Angenäherte Auflösung von Systemen linearer Gleichungen, „Bulletin International de l’Académie Polonaise des Sciences et des Lettres. Classe des Sciences Mathématiques et Naturelles. Série A, Sciences Mathématiques” 1937, vol 35.

Kapusta Paweł i in., Distributed, Multi-GPU System for Solving Linear Reconstruction Algorithms in 3D Electrical Capacitance Tomography, “Image Processing & Communications” 2014, vol. 19.

Lionheart William RB. Review: Developments in EIT reconstruction algorithms: pitfalls, challenges and recent developments, “Measurement Science and Technology” 2004, vol. 25. DOI: https://doi.org/10.1088/0967-3334/25/1/021

Matusiak Bartosz i in., Forward problem solution acceleration with graphical processing units (GPU) for electrical tomography imaging, 7th World Congress on Industrial Process Tomography, Cracow 2013.

Mirkowski Jacek i in., Parameters Optimization for Model Based Image Reconstruction in Electrical Capacitance Tomography, 4th World Congress on Industrial Process Tomography, Aizu 2005.

Mosorow Wolodymyr, Application of tomography in reaction engineering (mixing process), Industrial Tomography, Systems and Applications [Mi Wang eds.], Woodhead Publishing, Elsevier 2015. DOI: https://doi.org/10.1016/B978-1-78242-118-4.00019-8

Pląskowski Andrzej i in., Imaging Industrial flows, applications of electrical process tomography, Bristol 1995.

Process Tomography Ltd., 2001, Generation of ECT images from capacitance measurements, PTL APPLICATION NOTE AN1, http://www.tomography.com/.

Process Tomography, Process Imaging for automatic control, eds. Scott David M., McCann Hugh, Taylor and Francis Group 2005.

Process Tomography: Principles, Techniques and Applications, eds. Williams Richard A., Beck Maurice S Butterworth-Heinemann, Oxford UK 1995.

Przywarski Rafał i in., Metody wyznaczania map czułości dla systemu tomografii optycznej, „Automatyka”, t. 11, z. 3.

Romanowski Andrzej i in., Advanced Statistical Analysis as a Novel Tool to Pneumatic Conveying Monitoring and Control Strategy Development, “Particle & Particle Systems Characterization” 2006, vol. 23, Issue 3–4. DOI: https://doi.org/10.1002/ppsc.200601059

Rząsa Mariusz i in, The Discrete Optical Tomograph including Five Projections, 5th World Congress on Industrial Process Tomography, Bergen 2007.

Sankowski Dominik, Mosorow Wolodymyr, Strzecha Krzysztof, Przetwarzanie i analiza obrazów w systemach przemysłowych, Warszawa 2011.

Sankowski Dominik, Sikora Jan, Electrical Capacitance Tomography. Theoretical Basis and Applications, praca zbiorowa, Warszawa 2010.

Seville Jonathan PK., Tuzun Ugur, Clift Roland, Processing of Particulate Solids, Blackie Academic, London 1997. DOI: https://doi.org/10.1007/978-94-009-1459-9

Sikora Jan, Filipowicz Stefan, Rymarczyk Tomasz, Comparing methods of image reconstruction in electrical impedance tomography, “Computer Applications In Electrical Engineering” 2011, vol. 9.

Someya Satoshi, Takei Masahiro, Direct Imaging Technology, Process Imaging for automatic control, eds. Scott & McCann, Taylor and Francis Group 2005. DOI: https://doi.org/10.1201/9781420028195.ch3

Suchecki Witold, Wykorzystanie metod optycznej analizy przepływu do weryfikacji modeli numerycznych CFD, „Inżynieria i Aparatura Chemiczna” 2001, 40, nr 6.

Tadeusiewicz Ryszard, Korohoda Przemysław, Komputerowa analiza i przetwarzanie obrazów, Kraków 1997.

Tarantola Albert, Inverse problem Theory: methods for data fitting and model parameter estimation, Elseviere Scientific Publishing Company 1987.

Wajman Radosław i in., Metrological evaluation of 3D electrical capacitance tomography measurement system for two-phase flow fraction determination, “Measurement Science and Technology” 2013, vol. 24. DOI: https://doi.org/10.1088/0957-0233/24/6/065302

Wajman Radosław, Mazurkiewicz Łukasz, Sankowski Dominik, The Sensitivity Map in the Image Reconstruction Process for Electrical Capacitance Tomography, 3rd International Symposium on Process Tomography in Poland, Łódź 2004.

Wajman Radosław, Nowa metoda rekonstrukcji obrazów dla potrzeb pojemnościowej tomografii procesowej, rozprawa doktorska, Politechnika Łódzka 2006.

Warsito Warsito, Fan Liang-Shih, Neural network multi-criteria optimization image reconstruction technique (NN-MOIRT) for linear and non-linear process tomography, “Chemical Engineering and Processing” 2003, vol. 42. DOI: https://doi.org/10.1016/S0255-2701(02)00204-0

Warsito Warsito, Marashdeh Qussai, Fan Liang-Shih, Electrical Capacitance Volume Tomography, “IEEE Sensors Journal” 2007, vol. 7, no. 4. DOI: https://doi.org/10.1109/JSEN.2007.891952

Yang Wuqiang, Design of electrical capacitance tomography sensors, “Measurement Science and Technology” 2010, nr 21. DOI: https://doi.org/10.1088/0957-0233/21/4/042001

Yang Wuqiang, Peng Lihui, Image reconstruction algorithms for electrical capacitance tomography, “Measurement Science and Technology” 2003, vol. 14. DOI: https://doi.org/10.1088/0957-0233/14/1/201

York Trevor, Status of electrical tomography in industrial applications, “Journal of Electronics Imaging” 2001, vol. 10. DOI: https://doi.org/10.1117/1.1377308